Hardware configuration

0 votes
9 views
asked Nov 9 by anonymous
Hello,

I downloaded your last version of EventIDE wich allows to custom the hardware configuration.

In my case I would like to install my experiment on two computers which are equiped with LPT port. But in my first computer the LTP port name is LPT 1 and in my second computer the LTP port is LPT 3.

When I do the configuration how can I set the name (LPT 1 or LPT 3) of the LPT port for each computer ?

Thank you in advance.

1 Answer

0 votes
answered Nov 9 by Ilia Korjoukov (12,620 points)

Hi,

First, you obviously need 2 configurations for your computers. Lets assume that you have the LPT element configured for the first computer (LPT1). Staying on the same computer, you create a new configuration and add a configuration record that replaces the LPT element with its copy. It should look like this:

Next, you switch to the 'Second computer' configuration and select the new LPT element there. You cannot configure it for LPT3 via a list of detected ports because LPT3 exists only on the second computer. However, you can enter the port base address manually, given that you know the base address of the LPT3 on the second computer. If you don't know it, run EventIDE there, select LPT3 and check the 'Base Address' value.  

Once you manually enter the address for LPT3, save your experiment and switch back to the base configuration. When you bring the experiment on the second computer, just switch to the 'Second computer' configuration with the LPT element configured for LPT3.

 

Welcome to EventIDE Q&A forum where you can ask questions about EventIDE software and receive answers from other members of the community

FAQ questions

Installation and License


Coding


Eye-tracking


EEG Analysis


Visual Stimuli


Runtime and Data Collection


Hardware

...